| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
despite documentation that makes it sound a lot different, the only
ABI-constraint difference between TLS variants II and I seems to be
that variant II stores the initial TLS segment immediately below the
thread pointer (i.e. the thread pointer points to the end of it) and
variant I stores the initial TLS segment above the thread pointer,
requiring the thread descriptor to be stored below. the actual value
stored in the thread pointer register also tends to have per-arch
random offsets applied to it for silly micro-optimization purposes.
with these changes applied, TLS should be basically working on all
supported archs except microblaze. I'm still working on getting the
necessary information and a working toolchain that can build TLS
binaries for microblaze, but in theory, static-linked programs with
TLS and dynamic-linked programs where only the main executable uses
TLS should already work on microblaze.
alignment constraints have not yet been heavily tested, so it's
possible that this code does not always align TLS segments correctly
on archs that need TLS variant I.
|
|
the code to exit the new thread/process after the start function
returns was mixed up in its syscall convention.
|
|
|
|
|
|
stale state information indicating that a thread was possibly blocked
at a cancellation point could get left behind if longjmp was used to
exit a signal handler that interrupted a cancellation point.
to fix the issue, we throw away the state information entirely and
simply compare the saved instruction pointer to a range of code
addresses in the __syscall_cp_asm function. all the ugly PIC work
(which becomes minimal anyway with this approach) is defered to
cancellation time instead of happening at every syscall, which should
improve performance too.
this commit also fixes cancellation on arm, which was mildly broken
(race condition, not checking cancellation flag once inside the
cancellation point zone). apparently i forgot to implement that. the
new arm code is untested, but appears correct; i'll test and fix it
later if there are problems.
|
|
|
|
this port assumes eabi calling conventions, eabi linux syscall
convention, and presence of the kernel helpers at 0xffff0f?0 needed
for threads support. otherwise it makes very few assumptions, and the
code should work even on armv4 without thumb support, as well as on
systems with thumb interworking. the bits headers declare this a
little endian system, but as far as i can tell the code should work
equally well on big endian.
some small details are probably broken; so far, testing has been
limited to qemu/aboriginal linux.
|
